Pack Surface and Label Application
Specify the surface receiving the top or side label and provide representative packs for the proposed contact arrangement.
Labelling and packaging systems
Tamp Label Applicators
Plan tamp-applied top and side labels around pack surface, label size and position, and whether the pack stops or moves. Trial the stroke and contact arrangement with representative packs, including printing where needed and label presence checks.
Speak directly with Lancing about tamp-applied top and side labels.
Quick answer
When is a tamp label applicator suitable for our packaging line?
Specify the pack surface, label size and position, along with whether the pack stops or moves during application. Trial the proposed stroke and contact arrangement on representative packs. Include printing where required, label presence checks and recovery after a missing label or incorrectly presented product.
Six useful questions
Describe what you need from tamp label applicators before choosing a solution
For routine production using tamp-applied top and side labels, share the normal condition, realistic range and difficult cases the finished system must handle.
Pack Range and Movement
Describe the pack range and whether each pack stops or moves during application. Include incorrectly presented product in recovery checks.
Label Size and Position
Supply the intended labels and define their size and required position so the proposed stroke and contact can be trialled.
Required Output and Production Pattern
State required output and format changes so trials reflect pack movement and the planned production pattern.
Cleaning, Access and Changeover
Describe cleaning and operator-access needs, and the pack and label formats changed between runs.
Printing, Label Presence and Recovery
Include printing where required. Agree label presence checks and recovery after a missing label or incorrectly presented product.
Applications
Two useful starting points for tamp label applicators
Compare pack surfaces and movement, label size and position, the proposed stroke and contact, and any printing requirements.
What happens next
Your route from an initial enquiry to a working solution
You can review decisions about cleaning, access and changeover method and finished-pack checks and reject handling at each stage.
- 01
Review Pack and Label Samples
Supply representative packs and labels, with surface details, required label position and whether the pack stops or moves during application.
- 02
Trial the Label Application Stroke and Contact
Trial the proposed stroke and contact arrangement on representative packs to check label size and position.
- 03
Integrate Infeed, Discharge, Controls and Access
Connect the equipment to your line, services and controls while resolving required output and production pattern for day-to-day operation.
- 04
Run Agreed Production and Changeover Checks
Confirm cleaning, access and changeover method, then complete and record finished-pack checks and reject handling before your operating team takes over.
Important limits
Know what needs a separate check
- The selected method must be trialled with representative product and packaging.
- Supplier tolerances and product-condition changes can alter pack presentation or label application.
- Equipment selection does not replace product, hygiene, packaging or regulatory validation.
Your final solution for tamp-applied top and side labels must reflect the law, current standards and site-specific risks that apply to your installation.